Chapter 33 Link Layer Discovery Protocol (LLDP)
GS2210 Series User’s Guide
298
33.6 LLDP Configuration
Use this screen to configure global LLDP settings on the Switch. Click Advanced Application >
LLDP > LLDP Configuration ( Click Here) to display the screen as shown next.
Inventory TLV The majority of IP Phones lack support of management protocols such as SNMP, so
LLDP-MED inventory TLVs are used to provide their inventory information to the Network
Connectivity Devices such as the Switch. The Inventory TLV may contain the following
information.
• Hardware Revision
• Software Revision
• Firmware Revision
• Model Name
• Manufacturer
• Serial Number
• Asset ID
Extended
Power via MDI
TLV
Extended Power Via MDI Discovery enables detailed power information to be advertised
by Media Endpoints, such as I P phones and Network Connectivity Devices such as the
Switch.
• Power Type - whether it is currently operating from primary power or is on backup
power (backup power may indicate to the Endpoint Device that it should move to a
power conservation mode).
• Power Source - whether or not the Endpoint is currently operating from an external
power source.
• Power Priority - the Endpoint Device’s power priority (which the Network Connectivity
Device may use to prioritize which devices will remain in service during power
shortages)
• Power Value - power requirement, in fractions of Watts, in current configuration
Table 141 Advanced Application > LLDP > LLDP Remote Status > LLDP Remote Port Status Detail
(MED TLV)
LABEL DESCRIPTION
To Next Page
Loading...
