Chapter 43 Access Control
GS2210 Series User’s Guide
363
Figure 255 Management > Access Control
43.3 Configuring SNMP
Use this screen to configure your SNMP settings.
Click Managem ent > Access Control > SNMP to view the screen as shown.
Figure 256 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 181 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the Get Comm unity string, which is the password for the incoming Get- and
GetNext- requests from the managem ent station.
The Get Comm unity string is only used by SNMP managers using SNMP version 2c or
lower.
To Next Page
Loading...
