Chapter 5 Initial Setup Example
GS2210 Series User’s Guide
43
2 In the Static VLAN screen, select ACTI VE, enter
a descriptive name in the Nam e field and enter 2
in the VLAN Group I D field for the VLAN2
network.
Note: The VLAN Group I D field in this screen and the VI D field in the I P Setup screen
refer to the same VLAN ID.
3 Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to configure port 1 to
be a permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly,
clear the TX Tagging check box to set the Switch to remove VLAN tags before sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost
when the Switch’s power is turned off.
5.1.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
To Next Page
Loading...
