GS2210 Series User’s Guide
64
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System I nfo, General Setup, Sw itch Setup, I P
Setup, Port Setup, PoE, I nterface Setup and I Pv6 screens.
8.1.1 What You Can Do
• Use the System I nfo screen (
Section 8.2 on page 64) to check the firmware version number.
• Use the General Setup screen (
Section 8.3 on page 66) to configure general settings such as
the system name and time.
• Use the Sw itch Setup screen (Section 8.5 on page 69) to choose your VLAN type, set the GARP
timers and assign priorities to queues.
• Use the I P Setup screen (Section 8.6 on page 70) to configure the Switch IP address, default
gateway device, and the management VLAN ID.
• Use the Port Setup screen (Section 8.7 on page 72) to configure Switch port settings.
• Use the PoE Status screens (
Section 8.8 on page 74) to view the current amount of power that
PDs are receiving from the Switch and set the priority levels for the Switch in distributing power
to PDs. This screen is available for PoE model(s) only.
• Use the I nterface Setup screens (
Section 8.9 on page 79) to configure Switch interface type
and interface ID settings.
• Use the I Pv6 screens (Section 8.10 on page 80) to view IPv6 status and IPv6 configuration.
• Use the DNS screen (
Section 8.11 on page 92) to configure the default domain name server.
8.2 System Information
In the navigation panel, click Basic Setting > System I nfo to display the screen as shown. Use
this screen to view general system information. You can check the firmware version number.
To Next Page
Loading...
