Chapter 36 OAM
GS2210 Series User’s Guide
325
Te st Cl i ck Test to begin the test.
Rem ote
Loopback Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to initiate
or terminate a remote-loopack test.
Start Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.
Table 157 Advanced Application > OAM > OAM Remote Loopback (continued)
LABEL DESCRIPTION
To Next Page
Loading...
