Chapter 16 Mirroring
MGS3520 Series User’s Guide
155
Figure 83 Advanced Application > Mirroring > RMirror-Destination
The following table describes the labels in this screen.
Table 55 Advanced Application > Mirroring > RMirror-Destination
LABEL DESCRIPTION
Active Select this check box to enable the rule. Clear this check box to disable it.
RMirror VLAN ID Enter the ID number of the RMirror VLAN over which the mirrored traffic is forwarded.
Monitor Port Specify the port to which you copy the traffic in order to examine it in more detail
without interfering with the traffic flow on the original port(s).
Tagging Select whether to add the RMirror VLAN tag to mirrored traffic on the monitor port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
