ZyXEL Communications MGS3520 Series - Configuring SNMP

Chapter 42 Access Control
MGS3520 Series User’s Guide
355
42.3.4 Configuring SNMP
Click Management > Access Control > SNMP to view the screen as shown. Use this screen to
configure your SNMP settings.
Table 177 SNMP Switch Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
stp STPNewRoot 1.3.6.1.2.1.17.0.1 This trap is sent when the STP root switch changes.
zyMrstpNewRoot 1.3.6.1.4.1.890.1.15
.3.52.3.1
This trap is sent when the MRSTP root switch
changes.
zyMstpNewRoot 1.3.6.1.4.1.890.1.15
.3.53.3.1
This trap is sent when the MSTP root switch changes.
STPTopologyChange 1.3.6.1.2.1.17.0.2 This trap is sent when the STP topology changes.
zyMrstpTopologyChange 1.3.6.1.4.1.890.1.15
.3.52.3.2
This trap is sent when the MRSTP topology changes.
zyMstpTopologyChange 1.3.6.1.4.1.890.1.15
.3.53.3.2
This trap is sent when the MSTP root switch changes.
mactable zyMacForwardingTableFull 1.3.6.1.4.1.890.1.15
.3.48.2.1
This trap is sent when more than 99% of the MAC
table is used.
zyMacForwardingTableFullReco
vered
1.3.6.1.4.1.890.1.15
.3.48.2.2
This trap is sent when the MAC address switching
table has become normal from full.
rmon RmonRisingAlarm 1.3.6.1.2.1.16.0.1 This trap is sent when a variable goes over the RMON
"rising" threshold.
RmonFallingAlarm 1.3.6.1.2.1.16.0.2 This trap is sent when the variable falls below the
RMON "falling" threshold.
cfm dot1agCfmFaultAlarm 1.3.111.2.802.1.1.8.
0.1
The trap is sent when the Switch detects a
connectivity fault.