Chapter 25 Multicast
MGS3520 Series User’s Guide
212
Figure 121 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Port Role
Setting
The following table describes the fields in the above screen.
Table 90 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Port Role
Setting
LABEL DESCRIPTION
MLD Snooping-proxy
VLAN ID
Select the VLAN ID for which you want to configure a port’s MLD snooping-proxy
settings.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Changes in this row are copied to all the ports as soon as you make them.
Port Role A port on the Switch can be either a Downstream port or Upstream port in MLD. A
downstream port connects to MLD hosts and acts as a multicast router to send MLD
queries and listen to the MLD host’s Report and Done messages. An upstream port
connects to a multicast router and works as a host to send Report or Done messages
when receiving queries from a multicast router.
Otherwise, select None if the port is not joining a multicast group or does not belong
to this VLAN.
To Next Page
Loading...
