EasyManua.ls Logo

ZyXEL Communications MGS3520 Series - Page 97

ZyXEL Communications MGS3520 Series
431 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 8 Basic Setting
MGS3520 Series User’s Guide
97
Figure 42 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
The following table describes the labels in this screen.
Table 24 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
LABEL DESCRIPTION
Interface Type Select the type of IPv6 interface for which you want to configure. The Switch supports
the VLAN interface type for IPv6 at the time of writing.
Interface ID Specify a unique identification number (from 1 to 4094) for the interface.
Note: A static IPv6 neighbor entry displays in the Management > Neighbor Table
screen only when the interface ID is also created in the Basic Setup > Interface
Setup screen.
Note: To have IPv6 function properly, you should configure a static VLAN with the same
ID number in the Advanced Setup > VLAN screens.
Neighbor Address Specify the IPv6 address of the neighboring device which can be reached through the
interface.
MAC Specify the MAC address of the neighboring device which can be reached through the
interface.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the nonvolatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
Index This is the interface index number. Click on an index number to change the settings.
Interface This is the name of the IPv6 interface you created.
Neighbor Address This field displays the IPv6 address of the neighboring device which can be reached
through the interface
MAC This field displays the MAC address of the neighboring device which can be reached
through the interface.
Delete Check the entry(ies) that you want to remove in the Delete column and then click
Delete to remove the selected entry(ies) from the summary table.
Cancel Click Cancel to clear the Delete check boxes.

Table of Contents

Related product manuals