Chapter 8 Control Panel: Network
NAS Series User’s Guide
132
The following table describes the labels in this screen.
8.4.2.1 Create a Port Trunking
Link aggregation combines LAN1 and LAN2 into a single logical link with greater bandwidth. Both
interfaces use the same IP address and MAC address. It also includes fault tolerance and load
balancing. Connect LAN1 and LAN2 to the same Ethernet switch.
Figure 101 Link Aggregation
Use this screen to set up port trunking. Click Control Panel > Network > TCP/IP > Network Interface, and
then click Create.
Table 75 Control Panel > Network > TCP/IP > Network Interface
LABEL DESCRIPTION
Create This button is available only on the NAS which has multiple Ethernet ports.
Click it to open the following screen to set up a port trunking.
For adding a port trunking, see Section 8.4.2.1 on page 132.
Edit Select the LANx interface and click this to modify the IPv4 or IPv6 settings. See Section
8.4.2.2 on page 133.
Select the ppp0 interface and click this to edit the PPPoE settings. See Section 8.4.2.3 on
page 135.
Remove This button is available only on the NAS which has multiple Ethernet ports and when a port
trunking is created.
Click this to remove the port trunking.
Status This shows the data transmission rate and duplex setting (full-duplex or half-duplex) of the
interface. This field is left blank if the interface is not connected.
A green ball signifies that this interface is active. A gray ball signifies that this interface is not
active.
Interface This shows the interface name.
IP Settings This shows whether the interface obtains the IP settings automatically or the IP address
information is configured manually.
IP Address This shows the IP address of an interface.
Subnet Mask This shows the subnet mask of an interface.
To Next Page
Loading...
