Chapter 8 Control Panel: Network
NAS Series User’s Guide
133
Figure 102 Creating a Port Trunking
The following table describes the labels in this screen.
8.4.2.2 Edit LAN1
Use this screen to configure IPv4 and/or IPv6 settings for LAN1. Select the LAN1 interface and then click
Edit.
IPv4
Click IPv4 to configure the IPv4 settings.
Table 76 Control Panel > Network > TCP/IP > Network Interface > Create
LABEL DESCRIPTION
Automatically Select this option to have the interface get IP address information automatically.
If no IP address information is assigned, the NAS uses Auto-IP to assign itself an IP address
and subnet mask. For example, you could connect the NAS directly to your computer. If
the computer is also set to get an IP address automatically, the computer and the NAS will
choose addresses for themselves and be able to communicate.
Manually Select this option for the interface to use fixed TCP/IP information. You must fill in the
following fields.
IP Address - Type an IP address in this field.
Subnet Mask - Type an IP subnet mask in this field.
Default Gateway - Type a default gateway address in this field.
Create Click this to save the settings and create a port trunking.
Cancel Click this to return to the previous screen without saving.
To Next Page
Loading...
