Chapter 8 Control Panel: Network
NAS Series User’s Guide
135
Figure 104 Control Panel > Network > TCP/IP > Network Interface > LAN1: IPv6
The following table describes the labels in this screen.
8.4.2.3 Configure PPPoE Settings
Use this screen to configure PPPoE settings for a direct Internet connection. Select the ppp0 interface
and then click Edit.
Table 78 Control Panel > Network > TCP/IP > Network Interface > LAN1: IPv6
LABEL DESCRIPTION
Configure IPv6 Select Auto to have the NAS use the IPv6 prefix from the connected router’s Router
Advertisement (RA) to generate an IPv6 address.
Select Manual if you have a fixed IPv6 address assigned by your ISP.
Select Disable to not assign any IPv6 address for the NAS.
IPv6 Address Enter the IPv6 address assigned by your ISP if you select Manual.
Subnet prefix
length
Enter the address prefix length to specify how many most significant bits in an IPv6 address
compose the network address. The range is 0 to 128.
Default
Gateway
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
segment as your NAS's interface(s). The gateway helps forward packets to their destinations.
Apply Click this to save your changes.
Cancel Click this to return to the previous screen without saving.
To Next Page
Loading...
