ZyXEL Communications NAS540 - Configure Network Diagnosis

Chapter 8 Control Panel: Network
NAS Series User’s Guide
137
Figure 106 Control Panel > Network > TCP/IP > Web Configurator
The following table describes the labels in this screen.
8.4.4 Configure Network Diagnosis
Click Control Panel > Network > TCP/IP > Network Diagnosis to test the network connection to a
particular IP address or domain name.
Table 80 Control Panel > Network > TCP/IP > Web Configurator
LABEL DESCRIPTION
HTTP connection
Port Number Specify the port number of HTTP connection.
Note: The port number 8082 is reserved for media streaming.
Enable HTTPS
connection
Select or clear this field to enable or disable HTTPS connection.
Port Number Specify the port number of HTTPS connection.
Allow only
HTTPS
connection
Select this field to allow connection to the Web Configurator via HTTPS only. Clear this field to
allow connection to the Web Configurator via both HTTP and HTTPS.
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.