Chapter 16 Backup Planner
NAS Series User’s Guide
278
Edit Job: Source and Destination
Click the Source and Destination tab to open the following screen. This screen is read-only. It shows the
path of the source folder for backup and on which volume (whether internal or external) the backup
files are stored. If the target location is a remote NAS, this shows the remote IP address. Click Apply to
save your changes or click Cancel to close the screen without saving.
Figure 222 Backup Planner > Backup > Edit Job: Source and Destination
Edit Job: Schedule and Options
Use this screen to edit the schedule (and bandwidth) for the backup job.
To Next Page
Loading...
