Chapter 7 Storage
NSA210 User’s Guide
151
Note: Once you create the first volume on the NSA, it is recommended to restart the
NSA for better performance.
7.4.2 Editing a Volume
Click an internal volume’s Edit icon in the Storage > Volume screen as shown in
Section 7.4 on page 147 to open the following screen. Use this screen to change
the volume’s name.
Figure 49 Storage > Volume > Edit
The following table describes the labels in this screen.
RAID 1 Use this if you want to mirror all data on one disk to the other disk.
This is only available when you have two hard disks installed (that is,
the hard disk inside the NSA and an eSATA hard disk attached to the
NSA.
The External Disk and Internal Disk boxes are automatically
checked.
Apply Click this to save your changes and create the volume.
Cancel Click this to exit this screen without saving your changes or creating a
volume.
Table 20 Storage > Volume > Create a SATA Volume (continued)
Table 21 Storage > Volume > Edit
LABEL DESCRIPTION
Volume Name For an internal volume, type a volume name from 1 to 31
characters. To avoid confusion, it is highly recommended that
each volume use a unique name.
Acceptable characters are all alphanumeric characters and " "
[spaces], "_" [underscores], and "." [periods].
The first character must be alphanumeric (A-Z, 0-9).
The last character cannot be a space " ".
For an external volume, type a volume name from 1 to 32
single-byte (no Chinese characters allowed for example) ASCII
characters. The name cannot be the same as another existing
external volume.
Apply Click this to save your changes and rename the volume.
Cancel Click this to close this screen without saving your changes.
To Next Page
Loading...
