ZyXEL Communications NSA210 - Create a SATA Volume Button

Chapter 4 Tutorials
NSA210 User’s Guide
61
2 Click the Migrate button and you can see the following progress bar. Wait for up
to 10 minutes for the RAID 1 volume to be created.
4.2.3 Create a SATA Volume Button
If you do not have an existing volume in the Storage > Volume screen, do the
following steps to create a RAID 1 volume.
1 In the Storage > Volume screen, click Create a SATA Volume.
2 In the Disk Configuration screen, you can select the storage method.
• Type in the Volume Name for your RAID 1 volume. The volume name can be 1
to 31 characters (a-z, 0-9, " " [spaces], "_", and ".").
• Choose RAID 1 and click Apply.
This deletes all existing data in the eSATA hard disk. Make sure
you have a backup of any existing data in the hard disk.