P-660 Series Support Notes
2. Firmware/Configurations Uploading and Downloading using TFTP
• Using TFTP client software
• Using TFTP command on Windows NT
• Using TFTP command on UNIX
Using TFTP client software
• Upload/download ZyNOS via LAN
• Upload/download SMT configurations via LAN
Using TFTP to upload/download ZyNOS via LAN
• TELNET to your Prestige first before running the TFTP software
• Type the CI command 'sys stdio 0' to disable console idle timeout in Menu
24.8 and stay in Menu 24.8
• Run the TFTP client software
• Enter the IP address of the Prestige
• To upload the firmware, please save the remote file as 'ras' to Prestige. After
the transfer is complete, the Prestige will program the upgraded firmware into
FLASH ROM and reboot itself.
An example:
The 192.168.1.1 is the IP address of the Prestige. The local file is the source file of the
ZyNOS firmware that is available in your hard disk. The remote file is the file name
that will be saved in Prestige. Check the port number 69 and 512-Octet blocks for
TFTP. Check 'Binary' mode for file transfering.
105
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
