ZyXEL Communications P-660 series - Using FTP Client Software

P-660 Series Support Notes
the IP address of the Prestige.
Step2
Press 'Enter' key to ignore the username, because the Prestige does not check
the username.
Step 3
Enter the SMT password as the FTP login password, the default is '1234'.
Step 4
Enter command 'bin' to set the transfer type to binary.
Step 5
Use 'put' command to transfer the file to the Prestige.
Note: The remote file name for the firmware is 'ras' and for the configuration file is
'rom-0' (rom-zero, not capital o).
Example:
C:\temp>ftp 192.168.1.1
Connected to 192.168.1.1
220 FTP version 1.0 ready at Thu Jan 1 00:02:09 1970
User (192.168.1.1:(none)): <Enter>
331 Enter PASS command
Password:****
230 Logged in
ftp> bin
200 Type I OK
ftp> put prestige.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 924512 bytes sent in 4.83Seconds 191.41Kbytes/sec.
ftp>
Here, the 'prestige.bin' is the local file and 'ras' is the remote file that will be saved
in the Prestige.
The Prestige reboots automatically after the uploading is finished.
Using FTP client software
Step 1
Rename the local firmware and configuration files to 'ras' and 'rom-0', because we can not specify the
remote file name in the FTP client software.
Step 2
Use FTP client from your workstation to connect to the Prestige by entering the IP address of the
Prestige.
Step 3
Enter the SMT password as the FTP login password. The default is '1234'.
Step 4
Press 'OK' key to ignore the username, because the Prestige does not check the username.
109
All contents copyright © 2005 ZyXEL Communications Corporation.