P-660 Series Support Notes
Configuring NAT
To configure NAT, enter 15 from the Main Menu to bring up the following screen.
Menu 15 - NAT Setup
1. Address Mapping Sets
2. NAT Server Sets
Address Mapping Sets and NAT Server Sets
Use the Address Mapping Sets menus and submenus to create the mapping table used
to assign global addresses to LAN clients. Each remote node must specify which NAT
Address Mapping Set to use. The P-660 has 8 remote nodes and so allows you to
configure 8 NAT Address Mapping Set. You can see nine NAT Address Mapping sets
in Menu 15.1. You can only configure from Set 1 to Set 8. Set 255 is used for SUA.
When you select Full Feature in menu 4 or 11.3, you must enter correct NAT Set as
well. When you select SUA Only, the SMT will use Set 255.
The NAT Server Set is a list of LAN side servers mapped to external ports. To use
this set (one set for the P-660), a server rule must be set up inside the NAT Address
Mapping set. Please see NAT Server Sets for further information on these menus.
Enter 1 to bring up Menu 15.1-Address Mapping Sets
Menu 15.1 - Address Mapping Sets
1.
2.
3.
4.
5.
6.
7.
8.
255. SUA (Read Only)
Enter Set Number to Edit:
36
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
