ZyXEL Communications P-660 series - Using FTP to Upload the Firmware and Configuration Files; Using FTP Command in Terminal

P-660 Series Support Notes
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
Enter Menu Selection Number: 8
Copyright (c) 1994-2005 ZyXEL Communications Corp.
ras> sys stdio 0
(Open a new window)
[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 get rom-0 [local-rom] <- change to binary mode
<- download configurations
[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 put [local-rom] rom-0 <- upload configurations
[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 get ras [local-ras ] <- download firmware
[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 put [local-ras] ras <- upload firmware
3. Using FTP to Upload the Firmware and Configuration Files
In addition to upload the firmware and configuration file via the console port and
TFTP client, you can also upload the firmware and configuration files to the Prestige
using FTP.
To use this feature, your workstation must have a FTP client software. There are two
examples as shown below.
•
Using FTP command in terminal
•
Using FTP client software
Using FTP command in terminal
Step 1
Use FTP client from your workstation to connect to the Prestige by entering
108
All contents copyright © 2005 ZyXEL Communications Corporation.