P-660 Series Support Notes
ras> ip ro st
Dest FF Len Interface Gateway Metric stat Timer Use
192.168.3.0 00 24 enif0:1 192.168.3.1 1 041b 0 0
192.168.2.0 00 24 enif0:0 192.168.2.1 1 041b 0 0
192.168.1.0 00 24 enif0 192.168.1.1 1 041b 0 0
ras>
Two new protocol filter interfaces in menu 3.2.1 allow you to accept or deny LAN
packets from/to the IP alias 1 and IP alias 2 go through the P-660. The filter set in
menu 3.1 is used for main network configured in menu 3.2.
• IP Alias Setup
1. Edit the first network in menu 3.2 by configuring the P-660's first LAN IP
address.
Menu 3.2 - TCP/IP and DHCP Setup
DHCP Setup
DHCP= Server
Client IP Pool Starting Address= 192.168.1.33
Size of Client IP Pool= 6
Primary DNS Server= 168.95.1.1
Secondary DNS Server= 168.95.192.1
Remote DHCP Server= N/A
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
IP Policies=
Edit IP Alias= Yes
Press ENTER to Confirm or ESC to Cancel:
Key Settings:
DHCP
Setup
If the P-660's DHCP server is enabled, the IP pool for the clients can be any of the
three networks.
TCP/IP
Setup
Enter the first LAN IP address for the P-660. This will create the first route in the
enif0 interface.
83
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
