Chapter 19 Remote Management
P-79X Series User’s Guide
185
Click Advanced > Remote MGMT > SSH. The screen appears as shown.
Figure 113 Advanced > Remote MGMT> SSH
The following table describes the labels in this screen.
19.5 The SNMP Screen
Simple Network Management Protocol (SNMP) is a protocol used for exchanging management
information between network devices. SNMP is a member of the TCP/IP protocol suite. Your P-79X
supports SNMP agent functionality, which allows a manager station to manage and monitor the P-
79X through the network. The P-79X supports SNMP version one (SNMPv1) and version two
(SNMPv2). The next figure illustrates an SNMP management operation.
Note: SNMP is only available if TCP/IP is configured.
Table 75 Advanced > Remote MGMT > SSH
LABEL DESCRIPTION
Port This field displays the port number of the SSH service. You must use the same
port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the P-79X using
this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the
P-79X using this service.
Select All to allow any computer to access the P-79X using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the P-79X using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
