ZyXEL Communications P-791R v3 - Configuring more Connections Advanced Setup

Chapter 6 WAN Setup
P-79X Series User’s Guide
55
6.3.2 Configuring More Connections Advanced Setup
Use this screen to edit your P-79X's advanced WAN settings. Click the Advanced Setup button in
the More Connections Edit screen. The screen appears as shown.
Enter 802.1Q VLAN
ID[1-4094]
Specify a VLAN ID number.
IP Address This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet.
If you use the encapsulation type except ENET ENCAP, select Obtain an
IP Address Automatically when you have a dynamic IP address;
otherwise select Static IP Address and type your ISP assigned IP
address in the IP Address field below.
If you use ENET ENCAP, enter the IP address given by your ISP in the IP
Address field.
Subnet Mask Enter a subnet mask in dotted decimal notation.
Connection
Nailed-Up Connection Select Nailed-Up Connection when you want your connection up all the
time. The P-79X will try to bring up the connection automatically if it is
disconnected.
Connect on Demand Select Connect on Demand when you don't want the connection up all
the time and specify an idle time-out in the Max Idle Timeout field.
Max Idle Timeout Specify an idle time-out in the Max Idle Timeout field when you select
Connect on Demand. The default setting is 0, which means the Internet
session will not timeout.
NAT SUA only is available only when you select Routing in the Mode field.
Select SUA Only if you have one public IP address and want to use NAT.
Click Edit Detail to go to the Port Forwarding screen to edit a server
mapping set.
Otherwise, select None to disable NAT.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Advanced Setup Click this to display the More Connections Advanced Setup screen and
edit more details of your WAN setup.
Table 17 Network > WAN > More Connections: Edit (continued)
LABEL DESCRIPTION