ZyXEL Communications P-791R v3 - Set up the Server

Chapter 5 Tutorials
P-79X Series User’s Guide
41
To set up the point-to-2 point connection between A, B and C you need to:
1 Set up the Server.
2 Set up the Clients.
3 Connect the P-79Xs.
5.3.1 Set up the Server
1 Log in to the server P-79X of Company A.
2 Click Network > WAN > Internet Access Setup.
3 Configure the Internet Access Setup screen as the following. Select ATM as the Transfer Mode.
Select Bridge as the Mode. Configure the Multiplexing, Encapsulation, VPI, and VCI fields for
the point-to-point connection. Select 1 in the Line field as the DSL line you want the P-79X to use
as a default for outgoing traffic.
4 Then configure the Service Type section. Select 2 wire-2 line in the Service Mode field. In the
Service Type field, select Server. For Line1 configuration, select 5696 as the Transfer Max Rate
and 3200 as the Transfer Min Rate. For Line2 configuration, select 2560 as the Transfer Max
Rate and 1280 as the Transfer Min Rate. Leave the rest of the fields to their default settings.
Click Apply.
B
A
C
5696/3200 Kpbs
2560/1280 Kpbs