ZyXEL Communications PLA6456 - Page 20

Chapter 3 Web Configurator
PLA6456 User’s Guide
20
Figure 9 IP Screen
The following table describes the labels in this screen.
Table 6 Configuration Screen
LABEL DESCRIPTION
IPv4 configuration
DHCP enabled Select YES if your PLA is connected to a DHCP-enabled router that can assign it an IPv4 address.
The IPv4 address / netmask, Default Gateway, and DNS fields will be filled automatically when
configuration is received from the DHCPv4 server.
Select NO if you wish to assign an IPv4 Address, Subnet Mask, Default Gateway and DNS to your
PLA.
IPv4 address /
netmask
Enter the IPv4 address and subnet mask you wish to assign to your PLA.
This field is only available when you select No in the DHCP enabled field.
Default
Gateway
Enter the gateway IP address you wish to assign to your PLA.
This field is only available when you select No in the DHCP enabled field.
DNS Enter the IPv4 DNS server address you configure manually.
This field is only available when you select No in the DHCP enabled field.
Click Ok for the changes to take effect.
Note: All changes except the DNS server will only take effect after a system reboot.
IPv6 configuration