ZyXEL Communications PLA6456 - Log File Settings

Chapter 3 Web Configurator
PLA6456 User’s Guide
26
Upon clicking Ok for Broadcast suppression, reboot your PLA by clicking Hardware Reset to make the
changes when the next screen appears.
Figure 13 Hardware Reset
Note: Do NOT click Ok for Factory Reset.
3.8 Log File Settings
Use the Log file screen to allow your PLA to send event logs to an FTP server. You can set the data
capture time interval as well as how often it uploads to the FTP server.
Figure 14 Log File Screen
The following table describes the labels in this screen.
Broadcast xput
limit (Mbps)
Broadcast suppression prevents the Ethernet port from being overloaded by a broadcast storm.
In Broadcast xput limit, set the maximum throughput allowed before suppressing broadcast
traffic. 0 disables broadcast suppression.
Click Ok for the changes to take effect.
Table 9 Multicast Screen (continued)
LABEL DESCRIPTION
Table 10 Log file Screen
LABEL DESCRIPTION
Log File Configuration
Enable Log File Select YES to allow your PLA to send event logs to an FTP server. Otherwise, select NO to disable
it.
Data capture
interval(s)
This field allows you to set the time interval (1 ~ 9,999,999 seconds) to capture data.