ZyXEL Communications PLA6456 - Multiple Separate HomeGrid Networks

Chapter 2 RESET/ENCRYPT Button
PLA6456 User’s Guide
13
Figure 4 Adding More PLAs to Your Network
This sets up your HomeGrid network between your PLAs.
2.3 Multiple Separate HomeGrid Networks
You can use the RESET/ENCRYPT button to create multiple separate HomeGrid networks. Use the RESET/
ENCRYPT button on only two PLAs at a time.
1 Press the RESET/ENCRYPT button on PLAs E and F for 2 to 5 seconds. This must be done within 2 minutes
(120 seconds) of pressing the RESET/ENCRYPT button on the first PLA.
2 Wait for about one minute while PLAs E and F connect.
3 Now pair two different PLAs. Press the RESET/ENCRYPT button on PLAs G and H for 2 to 5 seconds and
within two minutes of each other.
4 Wait for about one minute while PLAs G and H connect.
5 When the power ( ) and Powerline ( ) lights shine steadily, the devices are connected.
A
B
C
A OR B
D
A OR B OR C