Chapter 3 Web Configurator
PLA6456 User’s Guide
24
Note: The PLA will reset and the Web Configurator will refresh to the Login screen upon
successful installation. It is recommended that you compare the software version shown
on the Web Configurator’s Device page FW version field with the firmware version
installed, to confirm if the installation was successful.
3.7 Multicast Settings
Multicast delivers IP packets to members defined by multicast groups. Membership to these multicast
groups are established using IGMP/MLD.
Internet Group Multicast Protocol (IGMP) is an IPv4 network-layer protocol used to establish membership
in a Multicast group - it is not used to carry user data.
Multicast Listener Discovery (MLD) is an IPv6 network-layer protocol that uses ICMPv6 message types,
rather than IGMP message types. MLDv1 is equivalent to IGMPv2 and MLDv2 is equivalent to IGMPv3.
Use the Multicast screen to configure IGMP/MLD settings.
Upgrade file Type the location of the file you want to upload in this field or click Browse to find it.
Note: Only use firmware for your PLA. Do NOT remove power from the PLA while
firmware upload is in progress!
Browse Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Click Ok to begin the upload process. This process may take up to two minutes. When the
Download Progress bar reaches 100 %, click Hardware Reset.
Table 8 Device Screen (continued)
LABEL DESCRIPTION
To Next Page
Loading...
