Chapter 4 HomeGrid Network Setup Tutorial
PLA6456 User’s Guide
30
Figure 17 Add a Printer to Your HomeGrid Network
Note: You do not need to know the domain name of the new adapter to add it to your
network.
1 Connect your computer to the PLA you want to add to your network and open the Web Configurator
(see Section 4.3 on page 28).
2 Go to the G.hn screen. On this screen in the Device ID field your new PLA should appear as 1 (A). Check
the Device ID 1 adapter’s MAC address (B). It should match the MAC address listed on the label on the
back of your PLA.
To Next Page
Loading...
