Chapter 3 Status
PMG1005-T20B User’s Guide
16
Each field is described in the following table.
3.3 Statistics Screen
Use this screen to look at the current number of the GPON Device packets received through the
Ethernet or the PON interface. Click Status > Statistics to open the following screen.
Table 5 Status > Device Info
LABEL DESCRIPTION
Device Information
Firmware Version This field displays the current version of the firmware the GPON Device uses.
Hardware version This field displays the current version of the hardware of the GPON Device.
MAC Address This is the MAC (Media Access Control) address unique to your GPON Device. The MAC
address uses six pairs of hexadecimal notation and follows an industry standard that
ensures no other adapter has the same address.
Model Name
Model Name This field displays the model name of the GPON Device.
LAN
IPv4
IP Address This field displays the current IP address of the GPON Device in the LAN. Click this to go to
the screen where you can change it.
Subnet Mask This field displays the GPON Device’s LAN subnet mask.
GPON
Link State This field displays Up when the interface has a connection with OLT (fiber terminal) and
Down when it does not.
Transceiver
Rx Power This field displays the transceiver’s optical receiving power in dBm. The normal range is -6 to
-28 dBm.
Tx Power This field displays the transceiver’s optical transmitting power in dBm. The normal range is .5
to 5 dBm.
Tx Bias Current This field displays the transceiver’s bias current in mA. The normal range is 4-50 mA.
Supply Voltage This field displays the transceiver’s voltage in Volts. The normal range is 3.13-3.47 Volts.
Temperature This field displays the transceiver’s temperature in Celsius. The normal range is 0-70 degrees.
To Next Page
Loading...
