PMG1005-T20B User’s Guide
21
CHAPTER 5
Access Management
5.1 Overview
• Use the SLID screen to change your GPON Device’s Subscriber Location ID (SLID) setting (Section 5.2
on page 21).
5.2 SLID Screen
To change your GPON Device’s Subscriber Location ID (SLID) setting, click Access Management > Auth.
The screen appears as shown. The SLID identifies your device to the GPON service provider’s
Optical
Line Terminal (OLT). If your GPON service provider gave you an SLID to use, enter it in this screen.
Figure 11 Access Management > Auth
The following table describes the fields in this screen.
Table 8 Access Management > Auth
LABEL DESCRIPTION
SLID Enter the SLID used for gaining access to the service provider’s network. It is case-sensitive,
so make sure [Caps Lock] is not on.
APPLY Click APPLY to save your changes back to the GPON Device.
To Next Page
Loading...
