ZyXEL Communications PMG1005-T20B - Chapter 6: Maintenance; 6.1 Overview; 6.2 Administration Screen

PMG1005-T20B User’s Guide
22
CHAPTER 6
Maintenance
6.1 Overview
• Use the Administration screen to change your GPON Device’s password (Section 6.2 on page 22).
• Use the Firmware screen to upload firmware to your GPON Device (Section 6.3 on page 22).
• Use the SysRestart screen to backup/restore or reboot the GPON Device without turning the power off
(Section 6.4 on page 24).
6.2 Administration Screen
Use this screen to configure the GPON Device’s password. Click Maintenance > Administration to open
the Administration screen.
Figure 12 Maintenance > Administration
The following table describes the labels in this screen.
6.3 Firmware Screen
Use the instructions in this screen to back up (save) the GPON Device’s configuration file or upgrade its
firmware. After you configure your GPON Device, you can backup the configuration file to a computer.
Table 9 Maintenance > Administration
LABEL DESCRIPTION
New Password Type your new system password (up to 30 characters). Note that as you type a password, the
screen displays a (*) for each character you type. After you change the password, use the
new password to access the GPON Device.
Confirm Password
Type the new password again for confirmation.
SAVE Click SAVE to save your changes back to the GPON Device.
CANCEL Click CANCEL to begin configuring this screen afresh.