PMG1005-T20B User’s Guide
19
CHAPTER 4
LAN
4.1 Overview
This chapter describes how to configure LAN settings.
A Local Area Network (LAN) is a shared communication system to which many computers are
attached. A LAN is a computer network limited to the immediate area, usually the same building or floor
of a building.
4.2 LAN Screen
Click Interface Setup > LAN to open the LAN screen. Use this screen to set the Local Area Network IP
address and subnet mask of your GPON Device.
Figure 10 Interface Setup > LAN
The following table describes the fields in this screen.
Table 7 Interface Setup > LAN
LABEL DESCRIPTION
Router Local IP
IP Address Enter the LAN IP address you want to assign to your GPON Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your GPON Device automatically computes the subnet
mask based on the IP address you enter, so do not change this field unless you are
instructed to do so.
Alias IP Address Enter the IP address of your GPON Device in dotted decimal notation.
To Next Page
Loading...
