Chapter 4 LAN
PMG1005-T20B User’s Guide
20
Alias IP Subnet Mask Your GPON Device will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask computed
by the GPON Device.
Snoop Select Activated to enable IGMP Snooping to forward group multicast traffic only to ports
that are members of that group. Otherwise, select Deactivated.
Dynamic Route RIP (Routing Information Protocol) allows a router to exchange routing information with
other routers.
Select the RIP version from RIP1 or RIP2.
Direction Use this field to control how much routing information the GPON Device sends and
receives on the subnet.
Select the RIP direction from None, Both, IN Only and OUT Only.
SAVE Click SAVE to save your changes back to the GPON Device.
CANCEL Click CANCEL to begin configuring this screen afresh.
Table 7 Interface Setup > LAN
LABEL DESCRIPTION
To Next Page
Loading...
