Chapter 8 Home Networking
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User’s Guide
129
Click Network Setting > Home Networking > Wake on LAN to open this screen.
Figure 60 Network Setting > Home Networking > Wake on LAN
The following table describes the labels in this screen.
8.8 TFTP Server Name
Use the TFTP Server Name screen to set the TFTP server address which is passed to the clients using DHCP
option 66. The DHCP clients in the VMG local network, such as STB devices that support the TFTP booting
mechanism, can then use the TFTP server address or domain name for initial system settings download.
RFC 2132 defines the option 66 open standard. DHCP option 66 carries the IP address or the domain
name of a single TFTP server.
Click Network Setting > Home Networking > TFTP Server Name to open this screen.
Figure 61 Network Setting > Home Networking > TFTP Server Name
The following table describes the labels in this screen.
Table 33 Network Setting > Home Networking > Wake on LAN
LABEL DESCRIPTION
Wake by
Address
Select Manual and enter the IP address or MAC address of the device to turn it on remotely. The
drop-down list also lists the IP addresses that can be found in the VMG’s ARP table. Select an IP
address and it will then automatically update the IP address and MAC address in the following
fields.
IP Address Enter the IPv4 IP address of the device to turn it on.
MAC Address Enter the MAC address of the device to turn it on. A MAC address consists of six hexadecimal
character pairs.
Wake up Click this to send a wake up packet to wake up the specified device.
Table 34 Network Setting > Home Networking > TFTP Server Name
LABEL DESCRIPTION
TFTP Server
Name
Enter the IP address or the domain name of a single TFTP server.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
