Chapter 9 VLAN
XGS1930 Series User’s Guide
118
Figure 89 Basic Setting > Switch Setup > Select VLAN Type
802.1Q Static VLAN
Make sure 802.1Q is selected in the Basic Setting > Switch Setup screen.
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified
VID.
9.3 VLAN Status
Use this screen to view and search all static VLAN groups. Click Advanced Application > VLAN from the
navigation panel to display the VLAN Status screen as shown next.
Figure 90 Advanced Application > VLAN: VLAN Status
To Next Page
Loading...
