Chapter 4 Web Configurator
XGS1930 Series User’s Guide
57
Figure 43 Wizard > QoS > QoS Setting
Each field is described in the following table.
4.5 Web Configurator Layout
The Status screen is the first screen that displays when you access the Web Configurator.
Table 16 Wizard > QoS > QoS Setting
LABEL DESCRIPTION
QoS Setting
Select all ports Select all ports to apply settings on all ports.
You can select a port by clicking it.
High Select ports and click the High button, so they will have high priority.
The port’s IEEE 802.1p priority level will be set to 5. Use the Basic Setting > Port Setup screen to
adjust the value.
Medium Select ports and click the Medium button and, so they will have medium priority.
The port’s IEEE 802.1p priority level will be set to 3. Use the Basic Setting > Port Setup screen to
adjust the value.
Low Select ports and click the Low button, so they will have low priority.
The port’s IEEE 802.1p priority level will be set to 1. Use the Basic Setting > Port Setup screen to
adjust the value.
Finish Review the information and click Finish to create the task.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
