ZyXEL Communications XGS1930-28 - VLAN Configuration; Configure a Static VLAN

Chapter 9 VLAN
XGS1930 Series User’s Guide
120
9.4 VLAN Configuration
Use this screen to view IEEE 802.1Q VLAN parameters for the Switch. Click Advanced Application > VLAN
> VLAN Configuration to see the following screen.
Figure 92 Advanced Application > VLAN > VLAN Configuration
The following table describes the labels in the above screen.
9.5 Configure a Static VLAN
Use this screen to configure a static VLAN for the Switch. Click the Static VLAN Setup link in the VLAN
Configuration screen to display the screen as shown next.
Elapsed Time This field shows how long it has been since a normal VLAN was registered or a static VLAN was
set up.
Status This field shows how this VLAN was added to the Switch.
• Dynamic: using GVRP
• Static: added as a permanent entry
• Voice: manually added as a Voice VLAN
Table 49 Advanced Application > VLAN > VLAN Detail (continued)
LABEL DESCRIPTION
Table 50 Advanced Application > VLAN > VLAN Configuration
LABEL DESCRIPTION
Static VLAN Setup Click Click Here to configure the Static VLAN for the Switch.
VLAN Port Setup Click Click Here to configure the VLAN Port for the Switch.
Voice VLAN Setup Click Click Here to configure the Voice VLAN for the Switch.
Vendor ID Based VLAN Setup Click Click Here to configure the Vendor ID Based VLAN for the Switch.