Chapter 50 Troubleshooting
XGS1930 Series User’s Guide
363
50.3 Switch Configuration
I lost my configuration settings after I restart the Switch.
Make sure you save your configuration into the Switch’s non-volatile
memory each time you make changes. Click Save at the top right of the
Web Configurator to save the configuration permanently. See also Section
36.2.2 on page 291 for more information about how to save your configuration.
I accidentally unplugged the Switch. I am not sure which configuration file will be loaded.
If you plug the power cable back to the Switch, it will reboot and load the configuration file that was
used the last time. For example, if Config 1 was used on the Switch before you accidentally unplugged
the Switch, Config 1 will be loaded when rebooting.
To Next Page
Loading...
