Chapter 47 Configure Clone
XGS1930 Series User’s Guide
347
Figure 257 Management > Configure Clone
The following table describes the labels in this screen.
Table 182 Management > Configure Clone
LABEL DESCRIPTION
Source/
Destination
Port
Enter the source port under the Source label. This port’s attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
2–6 indicates that ports 2 through 6 are the destination ports.
* Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to the
destination ports.
Advanced
Application
Select which port settings (you configured in the Advanced Application menus) should be copied
to the destination ports.
To Next Page
Loading...
