Chapter 4 Web Configurator
XGS1930 Series User’s Guide
41
Figure 25 Web Configurator: Login
4 Click Login to log into the Web Configurator to manage the Switch directly. The default user name is
admin and associated default password is 1234.
5 The Setup Wizard screen will appear. You can use the Setup Wizard screen to configure the Switch’s IP,
login password, SNMP community, link aggregation, and view a summary of the settings. See Section 4.4
on page 48 for more information on the Setup Wizard screen. When you finish configuring the settings,
you can click the Apply & Save button to make the settings take effect, and save your configuration
into the Switch’s non-volatile memory at once. Check the screens to see if the settings are applied.
Otherwise, click the Exit button. You can select the Ignore this wizard next time check box and click
Apply
& Save if you do not want the Setup Wizard screen to appear the next time you log in. If you want
to open the Setup Wizard screen later, click the Wizard icon in the upper right hand corner of the Web
Configurator.
To Next Page
Loading...
