Chapter 5 Initial Setup Example
XGS1930 Series User’s Guide
67
Figure 48 Initial Setup Example: Management IP Address
1 Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2 Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar to access the
Web Configurator. See Section 4.2 on page 40 for more information.
3 Click Basic Setting > IP Setup > IP Configuration in the navigation panel.
4 Configure the related fields in the screen.
5 For the VLAN2 network, enter 192.168.2.1 as the IP address and 255.255.255.0 as the subnet mask.
To Next Page
Loading...
