XGS2210 Series User’s Guide
132
Figure 103 Advanced Application > Static MAC Forwarding (Standalone mode)
Figure 104 Advanced Application > Static MAC Forwarding (Stacking mode)
The following table describes the labels in this screen.
Table 53 Advanced Application > Static MAC Forwarding
LABEL DESCRIPTION
Active Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Name Enter a descriptive name for identification purposes for this static MAC address forwarding rule.
MAC Address Enter the MAC address in valid MAC address format, that is, six hexadecimal character pairs.
Note: Static MAC addresses do not age out.
VID Enter the VLAN identification number.
Port
(standalone or
stacking
mode)
Enter the port where the MAC address entered in the previous field will be automatically
forwarded. In stacking mode, the first box field is the slot ID and the second field is the port
number.
Add Click Add to save your rule to the Switch’s run-time memory. The Switch loses this rule if it is turned
off or loses power, so use the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to their last saved values.
Clear Click Clear to begin configuring this screen afresh.
To Next Page
Loading...
