Chapter 36 Anti-Arpscan
XGS2210 Series User’s Guide
370
•Go to Basic Setting > Port Setup. Clear Active and click Apply. Then select Active and click Apply
again.
•Go to Application > Errdiable > Errdisable Recovery and set the interval for Anti-arpscan. After the
interval expires, the closed port(s) will become active and start receiving packets again.
• Use the command port no inactive.
• Refer to the port logs to see when a port was closed.
36.2 Anti-Arpscan Status
Use this screen to see what ports are trusted and are forwarding traffic or are disabled. To open this
screen, click Advanced Application > Anti-Arpscan.
Figure 283 Advanced Application > Anti-Arpscan Status (Standalone mode)
To Next Page
Loading...
