Chapter 24 Multicast
XGS2210 Series User’s Guide
242
24.5 General MVR Configuration
Multicast VLAN Registration (MVR) is designed for applications (such as Media-on-Demand (MoD)) that
use multicast traffic across an Ethernet ring-based service provider network.
MVR allows one single multicast VLAN to be shared among different subscriber VLANs on the network.
While isolated in different subscriber VLANs, connected devices can subscribe to and unsubscribe from
the multicast stream in the multicast VLAN. This improves bandwidth utilization with reduced multicast
traffic in the subscriber VLANs and simplifies multicast group management.
Use the MVR screen to create multicast VLANs and select the receiver port(s) and a source port for
each multicast VLAN. Click Advanced Application > Multicast > MVR to display the screen as shown
next.
Note: You can create up to five multicast VLANs and up to 256 multicast rules on the Switch.
Note: Your Switch automatically creates a static VLAN (with the same VID) when you create
a multicast VLAN in this screen.
Start Address This field displays the start of the multicast IPv6 address range.
End Address This field displays the end of the multicast IPv6 address range.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove, then click the Delete button. You can select the check box in the table heading
row to select all profiles.
To delete a rule(s) from a profile, select the rule(s) that you want to remove, then click the
Delete button.
Delete Click Delete button to permanently delete the entries you selected.
Cancel Click Cancel to clear the check boxes.
Table 98 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering Profile
LABEL DESCRIPTION
To Next Page
Loading...
