Chapter 24 Multicast
XGS2210 Series User’s Guide
246
Figure 185 Advanced Application > Multicast > MVR > Group Configuration
The following table describes the labels in this screen.
Table 100 Advanced Application > Multicast > MVR > Group Configuration
LABEL DESCRIPTION
Multicast VLAN ID Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
box.
Group Name Enter a descriptive name for identification purposes.
Start Address Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to IP Multicast Addresses on page 223 for more information on IP multicast addresses.
End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Refer to IP Multicast Addresses on page 223 for more information on IP multicast addresses.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
MVLAN This field displays the multicast VLAN ID.
Group Name This field displays the descriptive name for this setting.
Start Address This field displays the starting IP address of the multicast group.
End Address This field displays the ending IP address of the multicast group.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove, then click the Delete button. You can select the check box in the table heading row
to select all profiles.
To delete a rule(s) from a profile, select the rule(s) that you want to remove, then click the
Delete button.
To Next Page
Loading...
