Chapter 35 Link Layer Discovery Protocol (LLDP)
XGS2210 Series User’s Guide
364
Figure 280 Advanced Application > LLDP > LLDP-MED Network Policy (Stacking mode)
The following table describes the labels in this screen.
Table 160 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESCRIPTION
Port Enter the port number to set up the LLDP-MED network policy. For Stacking mode the first field
box is the slot ID, the second field box is the port number.
Application Type Select the type of application used in the network policy.
•voice
• voice-signaling
•guest-voice
• guest-voice-signaling
•softphone-voice
• video-conferencing
• streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
•tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter “0”.
DSCP Enter the DSCP value of the network policy. The value is defined from 0 through 63 with the 0
representing use of the default DSCP value.
Priority Enter the priority value for the network policy.
Add Click Add after finish entering the network policy information. A summary table will list all the
Switch you’ve added.
Cancel Click Cancel to begin entering the information afresh.
Index This field displays the of index number of the network policy. Click an index number to edit
the rule.
Port This field displays the port number of the network policy.
Application Type This field displays the application type of the network policy.
Tag This field displays the Tag Status of the network policy.
VLAN This field displays the VLANID of the network policy.
Priority This field displays the priority value of the network policy.
DSCP This field displays the DSCP value of the network policy.
To Next Page
Loading...
