Chapter 36 Anti-Arpscan
XGS2210 Series User’s Guide
375
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Trusted State Select Untrusted or Trusted for the associated port. Anti-arpscan is not performed on trusted
hosts.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Table 165 Advanced Application > Anti-Arpscan > Configure (continued)
LABEL DESCRIPTION
To Next Page
Loading...
