Chapter 37 BPDU Guard
XGS2210 Series User’s Guide
379
Figure 292 Advanced Application > BPDU Guard > BPDU Guard Configuration (Stacking mode)
The following table describes the labels in this screen.
Table 167 Advanced Application > BPDU Guard > BPDU Guard Configuration
LABEL DESCRIPTION
Active Select this option to enable BPDU guard on the Switch.
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port This field displays the Switch’s port number. In stacking mode, the first number is the slot ID and
the second is the port number. * means all ports.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the BPDU guard feature on this port. The Switch shuts down this
port if there is any BPDU received on the port.
Clear this check box to disable the BPDU guard feature.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
