Chapter 30 IPSec VPN
ZyWALL USG Series User’s Guide
629
Figure 436 Configuration > VPN > IPSec VPN > Concentrator > Add/Edit
Each field is described in the following table.
30.5 Zyxel Device IPSec VPN Client Configuration
Provisioning
Use the Configuration > VPN > IPSec VPN > Configuration Provisioning screen to configure who can
retrieve VPN rule settings from the Zyxel Device using the Zyxel Device IPSec VPN Client. In the Zyxel
Device IPSec VPN Client, you just need to enter the IP address of the
Zyxel Device to get all the VPN rule
settings automatically. You do not need to manually configure all rule settings in the Zyxel Device IPSec
VPN client.
VPN rules for the Zyxel Device IPSec VPN Client have certain restrictions. They must not contain the
following settings:
• AH active protocol
• NULL encryption
• SHA512 authentication
Table 225 VPN > IPSec VPN > Concentrator > Add/Edit
LABEL DESCRIPTION
Name Enter the name of the concentrator. You may use 1-31 alphanumeric characters, underscores(_), or
dashes (-), but the first character cannot be a number. This value is case-sensitive.
Member Select the concentrator’s IPSec VPN connection policies.
Note: You must disable policy enforcement in each member. See Section 30.2.1 on page
612.
IPSec VPN connection policies that do not belong to a VPN concentrator appear under Available.
Select any VPN connection policies that you want to add to the VPN concentrator and click the right
arrow button to add them.
The VPN concentrator’s member VPN connections appear under Member. Select any VPN
connections that you want to remove from the VPN concentrator, and click the left arrow button to
remove them.
OK Click OK to save your changes in the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
